The attention of mounting servo motor encoder.！

When you mount the servo encoder,do not direct impact is applied to the shaft during installation.

Connect the servo motor encoder shaft to the machine, use a flexible connector. When the shaft mounted connector, not pushed hard. Even with the connector, due to poor installation, it is possible to add than the allowable axle load bigger load, or cause dial core and, therefore, pay special attention to.

Bearing life use conditions, the affected load bearing particularly large. The bearing load smaller than a predetermined load, can greatly extend bearing life.

Do not disassemble the encoder, to do so would undermine the anti-oil and anti-drip properties. Drip-proof product is not long-term immersion in water, oil, surface water, oil should be wiped clean.

Previous：Roundss RDE108mm Absolute Encoder Rotary Encoder RS485 Output Angle Sensor
Next：Analog output 4-20mA linear encoder Draw wire encoder DC5V sensor