The setup and maintenance of draw wire sensor ！

A, Draw wire sensor in the installation process has the following risk - when the wire rope is pulled out, is strictly prohibited suddenly let go, because the rope pulled out after tightening tension, such as suddenly let go, wire rope in the role of high-speed pull back, may The equipment and personnel caused some damage.
  B, the sensor installation and work can not exceed the maximum stroke, nor can the rope encoder rope to release the original rope clip, otherwise they will cause damage to the sensor.
  C, wire rope slowly put back when the red mark should be exposed in the rope out of the mouth, or likely to cause the rope quit or can not be pulled out.
D, the product shall not be demolished privately, such as the discovery is not within the scope of the warranty.

 hybrid encoder, non-magnetic encoder, multi-turn encoder, multi-turn combination encoder, draw wire encoder, digital readout, linear scale

Previous：Roundss high quality draw wire distance encoder 0-5V output signal
Next：Encoder accessory aluminium camlock coupling