Installation Linear Displacement Sensor Precautions！

The alignment of the linear displacement sensor is very good, but the parallelism can allow an error of ± 0.5mm, the angle can be allowed to ± 12 ° error. However, if the parallelism error and the angle error are too large, this will show the case of digital beating. When such a situation occurs, it is necessary to adjust the parallelism and angle.
In the connection process, be sure to pay more attention to the electronic ruler of the three lines can not be wrong, the power line and the output line can not be replaced. If the above line is wrong, then there will be a large linear error situation, it is difficult to control, the control accuracy will become very poor, and the display is prone to beating phenomenon and so on.

Previous：48mm servo motor absolute encoders with UVW signal 2000ppr
Next：Hot selling ! easy to install 1um or 5um optical 0-500mm range linear encoder